SPINOGY Xcontrol-E, Руководство по эксплуатации

Страница: 27 / 31

27
08 DISASSEMBLY AND DISPOSAL
08 Disassembly and disposal
08.1 Disassembly
The disassembly as well as the decommissioning of the Xcontrol-E may only be carried out by qualified staff.
During all work, the locally applicable occupational safety and accident prevention regulations as well as internal
company regulations must be observed and complied with. Suitable tools must be used for disassembly.
WARNING: Unauthorized staff
Unauthorized employees are not aware of the hazards in the respective work area. Failure to
comply with the personnel requisition can result in serious injury or even death.
WARNING: Repairs by operators or third parties are not permitted
Unauthorized repairs carried out by the operator or third parties can result in the product not
being in a perfect condition afterwards, which can lead to property damage and, in the worst
case, serious injury or even death.
The Xcontrol-E is to be put out of operation in the following steps:
01.
The entire machine or system must be taken out of operation before the Xcontrol-E is decommissioned. To
complete this, proceed as follows:
a. Stop the spindle and make sure that the shaft is absolutely stationary (eject the tool via pneumatic
actuation if necessary)
b. Activate the emergency stop of the machine or system (if separate to the Xcontrol-E)
c. Set the main switch of the machine or system to “0“ or “Off“
d. Secure the machine or system against unauthorized restarting
e. Disconnect the machine or system from the electric network. Physically disconnect the power supply
lines and discharge any stored residual energy.
02. Press the emergency stop of the Xcontrol-E.
03. Set the main switch of the Xcontrol-E to “0“ or “Off“.
04. Set the circuit breaker inside the Xcontrol-E to “0“ or “Off“.
05. The power supply cable leading to the Xcontrol-E must be disconnected from the electrical power supply.
06. Disconnect all connections to the spindle and the control unit (spindle connection lines, control lines, separate
PE Protective earth)
07. If necessary, the Xcontrol-E can be removed from the machine or wall
08.2 Disposal
The disposal of the Xcontrol-E, any accessories and the packaging must be carried out in accordance with the
relevant laws and regulations of the respective country. If in doubt, contact the relevant local authority or a waste
disposal company. Depending on the material, the individual components should preferably be recycled. Disposal
with domestic waste or similar facilities for the collection of municipal waste is not permitted.
After consulting SPINOGY, the Xcontrol-E can be returned directly to the manufacturer. In this case, a disposal
fee may be charged by the manufacturer.