SPINOGY Xcontrol-E, Руководство по эксплуатации

Страница: 19 / 31

19
05 INSTALLATION
The Xcontrol-E is to be installed in the following steps:
01. Mount the Xcontrol-E on the machine or on the wall.
02. Connect the separate protective earth conductor.
03. Connect the motor connection cable (orange) to the spindle.
04. Connect the sensor connection cable (green) to the spindle (only for spindles with sensors)
05. Connect the control cable to the terminals (not included in the scope of delivery).
06. Optionally: Connect an external emergency stop to the terminals (e.g. door safety switch).
07. Optionally: Connect the Xcontrol-P signal cable to the terminals.
08. Optionally: Connect the Xcool signal cable to the terminals.
09. Check, whether the main switch is set to 0/Off.
10. Check whether the circuit braker is set to 0/Off.
11. Check whether the emergency stop switch is activated.
12. Connect the power cord (directly, without power supply plug).
13. The circuit braker needs to be set to 1/On again.
The Xcontrol-E must be mounted vertically, the connection cables pointing downwards, as the heat convection
of the frequency inverter is vertical. In addition, the Xcontrol-E must be suspended with sufficient distance to
surrounding components so that the intake area of the fan and the air outlet remain free.