http://www.spincore.com
PulseBlasterESR-PRO-II
NOTE:
It is important to terminate all signals properly (i.e. with a 50 Ohm terminating resistor at the
end of your cable).
example4_24bit
This example program tests the maximum pulse sequence length. This program will test the entire
memory.
NOTE:
It is important to terminate all signals properly (i.e. with a 50 Ohm terminating resistor at the
end of your cable).
example5_24bit
This example program demonstrates the ability to change outputs every clock period.
NOTE:
It is important to terminate all signals properly (i.e. with a 50 Ohm terminating resistor at the
end of your cable).
reset
This program will generate a software reset. The device will cease outputting data, but the device will
keep the program. The board can be restarted using “trigger”
trigger
This program will generate a software trigger. The device will start outputting data stored in its
memory counter. The device can be stopped using reset.c.
2016/08/17
15
