http://www.spincore.com
PulseBlasterESR-PRO-II
IDC Headers
There are three IDC headers on the PulseBlasterESR-PRO-II, which provide access to the digital
outputs.
This design has 24 output bits, and only the first two IDC headers are used. The signal is carried on
pins 1-13 of each IDC header, although pin 13 is unused. The two headers are labeled Flag0..11_Out and
Flag12..23_Out. On each IDC header, the top row of pins (14-26) are grounds, and signals are carried on
bottom pins 1-13 of each header.
Each pin on an IDC header corresponds to a bit in the flag field of an instruction. The association
between bits and pins is shown in the table on the next page.
2016/08/17
10
Figure 5:
BNC T-Adapter on oscilloscope with coaxial
transmission line connected on the left and BNC 50
Ohm resistor connected on the right, to terminate the
line.
Figure 6:
IDC header pin-out
14 15 16 17 18 19 20 21 22 23 24 25 26
1 2 3 4 5 6 7 8 9 10 11 12 13
