http://www.spincore.com
PulseBlasterESR-PRO-II
Pin Assignments
Pin#
Flag0..11
Flag12..23
Flag24..35
1
Bit 0
(Bit 12)
Unused
2
Bit 1
(Bit 13)
Unused
3
Bit 2
(Bit 14)
Unused
4
Bit 3
(Bit 15)
Unused
5
Bit 4
(Bit 16)
Unused
6
Bit 5
(Bit 17)
Unused
7
Bit 6
(Bit 18)
Unused
8
Bit 7
(Bit 19)
Unused
9
Bit 8
(Bit 20)
Unused
10
(Bit 9)
(Bit 21)
Unused
11
(Bit 10)
(Bit 22)
Unused
12
(Bit 11)
(Bit 23)
Unused
13
Unused
Unused
Unused
14-26
Ground
Ground
Ground
Table 1:
IDC connector pin-outs.
HWTRIG/RESET Header
This is an input connector for hardware triggering (HW_Trigger) and resetting (HW_Reset). Pins 1
and 2 are the reset and trigger inputs, respectively, and pins 3 and 4 are grounds. Both inputs are pulled
high by an on board 10 kΩ pull-up resistor.
HW_Trigger
(pin 2) When this input is set to logical 0 (for example by shorting it with pin 4), a
hardware trigger is produced. This has the same effects as issuing a trigger through software, although
the hardware trigger is faster, since there are no software latencies involved.
HW_Reset
(pin 1) HW_Reset is not utilized in this design, please contact SpinCore Technologies,
Inc. if you would like to have this functionality enabled.
2016/08/17
11
Figure 7:
HWTRIG/RESET Header pin out.
2
4
1
3
