SPIERINGS SK597-AT4, Руководство пользователя, Страница: 129 / 256

SK597-AT4
Driving
Truck
SPIERINGS MOBILE CRANES USER MANUAL V 1.2 4-39
M
ei
2
0
1
8
C
h
a
n
g
e
s
a
n
d
t
y
p
o
g
ra
p
h
ic
a
l e
rr
o
rs
r
e
s
e
rv
e
d
.
©
2
0
1
8
S
p
ie
ri
n
g
s
M
o
b
ile
Cr
a
n
e
s
–
A
ll r
ig
h
ts
r
e
s
e
rv
e
d
.
Adjusting the axle height will be done in three groups:
•
Axles 1 and 2 up / down;
•
Axles 3 and 4 left-hand rear up / down;
•
Axles 3 and 4 right-hand rear up / down.
There is axle load compensation within the axle groups:
•
Axles 1 and 2;
•
Axles 3 and 4.
Switches axle height adjustment
The axle height adjustment is operated by the switches on the control panel ( Picture 4-17 ):
A. Switch all axles up / down ;
B. Switch axles 1 and 2 up / down ;
C. Switch axles left-hand rear up / down ;
D. Switch axles right-hand rear up / down ;
E. Switch levelling ;
F. Switch release axle height adjustment .
For using the axle height control , switch release axle height control must be operated.
If this switch is pressed, switches A to D can be operated:
- The spring load of the truck is NOT disabled.
4.13.2.1. Axle blocking
Each hydraulic cylinder is equipped with a spring accumulator, which causes the relevant axles to
spring.
CAUTION!
Use the function axle blocking only on a levelled and paved surface,
so the weight of the vehicle is distributed evenly over the wheels.
CAUTION!
Make sure when using the axle blocking, that all wheels are in contact with the
ground. All tyres must be curved (except possible retracted axles for the benefit of
a steering program).
This is necessary for not exceeding the maximum permissible axle load.
Picture 4-17