Sperry Marine 5016-CA, Руководство по эксплуатации, установке и обслуживанию

Страница: 37 / 132

Analogue Compass Repeaters 056376/A
Error Blink Codes 3-1
Chapter 3: Error Indication
When a repeater compass detects an error, the red error indicator
flashes or lights up permanently depending on error condition.
The error indication remains active until the cause of the error is elimi-
nated or no longer persists.
3.1 Error Blink Codes
When an error is detected, the error condition at hand is indicated by the
error indicator showing a corresponding blink code.
Table 3-1:
Repeater compass
error blink codes
Note
The repeater compasses do not possess an audible alarm indicator.
error condition/ blink
code corrective action
no activity at data in-
put
or
power-up failure
permanently on
Check whether data are present at source’s
output.
Check connection between source and re-
peater.
Check whether the repeater reacts to key
presses (dimming, synchronization). If keys
are not functional, the repeater did not enter
normal operational mode.
Cycle power.
If the error persists, send the repeater back to
Sperry Marine for exchange.
heading timeout
on / off for equal peri-
ods
Check whether source provides valid heading
data.
In NAVIGAT compass systems, check that
heading data originates from selected source
according to $PPLAN/$PPNSD sentence.
Check source’s protocol and baudrate settings.
Check whether repeater configuration is hard-
set to different parameters than source’s out-
put.
In case one or all source indicators are flash-
ing together with the error indicator see
“Heading Timeout with flashing Source Indi-
cator” on page 3-2 for additional information
and corrective action.
If the error persists, send the repeater back to
Sperry Marine for exchange.
synchronization fault
two short flashes fol-
lowed by a pause
Initiate synchronization of the compass cards.
Cycle power.
If the error persists after several attempts to
synchronize, return the repeater to Sperry Ma-
rine for exchange.