Chapter 4 - Installation
Installing Additional Drives
6.
Using a #2 Phillips screwdriver, install one chassis screw (6) into the hole in the mounting
bracket on each side of the chassis to secure the chassis to the rack. Do not over-tighten
the screw.
Figure 39
Secure the chassis to the rack (front left
shown).
7.
Attach the front bezel by aligning the bezel to the pogo pins on the chassis and allowing
the magnet on the bezel to pull the bezel into the mounted position. No screws are used
to hold the bezel.
Installing Additional Drives
The BlackPearl NAS 2U master node ships with all drives installed.
The BlackPearl NAS 4U master node ships with 10 drives installed in the front of the chassis.
The BlackPearl NAS expansion node ships without drives installed. If you purchased
additional drives with your order, they ship in a separate box. Install the additional drives
before you begin using the system. If you do not have additional drives to install, continue
with
Connecting the Power Cords on page 56
Install additional drives in to the BlackPearl NAS 4U chassis until you have installed every
additional drive, or the chassis is full. Install any additional drives in BlackPearl NAS
expansion nodes.
January 2022
Installation Guide-Spectra BlackPearl NAS Solution
- 50 -