![background image](http://html1.mh-extra.com/html/speck-pumps/badu-ecom2-s90/badu-ecom2-s90_installation-operating-and-service-manual_1341830003.webp)
OWNER’S MANUAL
Swimming Pool Pump
READ THIS MANUAL CAREFULLY
BEFORE USING THE SPECK PUMP
Important Notice:
This manual contains important information about the installation, operation and safe
use of this product. This information should be given to the owner and/or operator of this equipment.
WARNING: This product must be installed and serviced by a qualified pool professional, and must conform to all
national, state, and local codes.
WARNING: Before installing this product, read and follow all warning notices and instructions which are included.
Failure to follow safety warnings and instructions can result in severe injury, death, or property damage. Call
(800) 223-8538 or visit www.usa.speck-pumps.com for additional copies of these instructions.
IMPORTANT SAFETY INSTRUCTIONS
1.
READ AND FOLLOW ALL
INSTRUCTIONS.
7. The unit must be connected only to a supply circuit
that is protected by a ground-fault circuit-interrupter
(GFCI). Such a GFCI should be provided by the installer
and should be tested on a routine basis. To test the
GFCI, push the test button. The GFCI should interrupt
power. Push the reset button. Power should be
restored. If the GFCI fails to operate in this manner,
the GFCI is defective. If the GFCI interrupts power to
the pump without the test button being pushed, a
ground current is flowing, indicating the possibility of
an electric shock. Do not use this pump. Disconnect the
pump and have the problem corrected by a qualified
service representative before using.
8. TO REDUCE RISK OF ELECTRICAL SHOCK, A copper
bonding connector (8 AWG) is provided for bonding the
motor to all metal parts of the swimming pool, spa, or
hot tub structure and to all electrical equipment, metal
conduit, and metal piping within 5 feet of the inside
walls of a swimming pool, spa, or hot tub, when the
motor is installed within 5 feet of the inside walls of
the swimming pool, spa, or hot tub.
NOTE: To installer and/or operator of the Speck
Swimming Pool Pump; the manufacturer’s warranty
will be voided if the pump is improperly installed and/
or operated.
9.
SAVE THESE
INSTRUCTIONS!
2. WARNING - To reduce the risk of injury, DO NOT
permit children to use this product unless they are
closely supervised at all times.
3. WARNING - Risk of Electrical Shock. Connect only
to a branch circuit protected by a ground-fault circuit
interrupter (GFCI). Contact a qualified electrician if you
cannot verify that a circuit is protected by a GFCI.
4. WARNING - To reduce the risk of electric shock,
replace any damaged cord immediately.
5. DO NOT install within an outer enclosure or beneath
the skirt of a hot tub or spa.
6. CAUTION - This pump is for use with permanently-
installed pools and may also be used with hot tubs and
spas if so marked. DO NOT use with storable pools. A
permanently-installed pool is constructed in or on the
ground or in a building such that it cannot be readily
disassembled for storage. A storable pool is constructed
so that it is capable of being readily disassembled for
storage and reassembled to its original integrity.
When installing and using this electrical equipment,
basic safety precautions should always be followed,
including the following:
Содержание BADU ECOM2/S90
Страница 1: ...Installation Operating and Service Manual BADU EcoM2 S90 Swimming Pool Pump...
Страница 27: ......
Страница 28: ......