Speck pumps 1.1 THP Dual Voltage Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 17 / 28

17
Controller Errors
WARNING: The pump must be serviced by a professional service technician qualified in pool/spa installation. The following
procedures must be followed exactly. Improper installation and/or operation can create dangerous electrical hazards, which
can cause high voltage to run through the electrical system. This can cause property damage, serious personal injury, and/
or death. Improper installation and/or operation will void the warranty.
The controller errors are indicated by the red LED and an error code shown in the LED display (See Figure 5). List of error
codes with their descriptions are listed in Table 2.0.
NOTE: In the event that an error code is shown and will not clear, the controller can be ‘rebooted’ by turning power
to the pump OFF and waiting 10 minutes before turning the power back on. If this step does not clear the error
code, contact your pool professional for service.
6
Troubleshooting
Table 2.0
Figure 5
Error Code Error Description
01 DC-link over-voltage
02 DC-link under-voltage
03 DC-link voltage is too low
04 IPM (Intelligent Power Module) over-current software protection
05 IPM (Intelligent Power Module) over-current hardware protection
07 AC input over-voltage
08 AC input under-voltage
10 Electronic thermal overload has tripped
11 Motor speed too high
13 IPM (Intelligent Power Module) temperature too high
16 Motor out of step
17 PFC output DC low voltage
20 Short circuit to ground
21 Motor phase short circuit
22 Output phase lack
31 Communication error with master
41 Current sampling sensor error
42 Inrush current preventing relay error
43 Voltage sensor error, AC voltage and DC voltage do not match
51 IPM (Intelligent Power Module) temperature sensor error
60 Motor rotor locked
61 DSP ROM error
62 DSP RAM error
63 DSP watchdog error
66 Internal communication error
ERROR POWER
SET
OK
0


3 2 1
E 0 5