Speck pumps 1.1 THP Dual Voltage Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 13 / 28

13
SET
Override (OVRD) Menu
1. Enter programing mode by pressing and holding the button for at least three (3) seconds when the pump is in the
stopped (OFF) position.
2. Use the and buttons to select OVRD. See Figure 8. Press the button to enter the override menu.

1
ERROR

3
OK
2
ERROR POWER
SET
OK
0


3 2 1
S C H E
ERROR POWER
SET
OK
0


3 2 1
o U A O
ERROR POWER
SET
OK
0


3 2 1
P A
Figure 8 - OVRD Shown on Display
3. The duration (hours) for the override feature flashes on the LED display. The factory default setting is two (2) hours. Use
the and buttons to select the desired number of hours for the override feature. The duration can be set between 0
and 24 hours. Press the button to save the override duration and exit the override and programming menus.
To Activate the Override Feature:
First press the button and then the button simultaneously when the pump is running. The pump will ramp up to full
speed (1000 Watts) for the programmed override duration. At the end of the programmed time for the override feature, the
pump will return to the proper place in the 24-hour schedule.

1
ERROR

3
OK
2
SET
ERROR

3
Priming (PR) Menu
1. Enter programming mode by pressing and holding the button for at least three (3) seconds when the pump is in the
stopped (OFF) position.
2. Use the and buttons to select PR. See Figure 9. Press the button to enter the priming menu.
SET

1
ERROR

3
OK
2
ERROR POWER
SET
OK
0


3 2 1
S C H E
ERROR POWER
SET
OK
0


3 2 1
o U A O
ERROR POWER
SET
OK
0


3 2 1
P A
Figure 9 - PR Shown on Display
3. The power level (watts) for the priming cycle flashes on the LED display. The factory default setting is 1000 Watts. Use
the and buttons to select the desired priming power level. Press the button to save and move on to the priming
time.

1
ERROR

3
OK
2