A
B
C
1
E
D
2
3
SPEED SENSOR HORST ASSEMBLY
# PART NAME
PART NUMBER
QTY
SPEC
TOOL
TORQUE
COMMENT
Nm
in-lbf
A
Speed Sensor Cable
1
N/A
N/A
N/A
B
Speed Sensor Grommet
1
N/A
N/A
N/A
C
Speed Sensor Bolt
1
M4 x 8 mm x 0.7mm p
3 mm hex
1
9
D
Speed Sensor Magnet Bolt
2
M5 x15 mm x 0.8 m p
T25 Torx
6.2
55
E
Speed Sensor Magnet
1
WARNING! Dirt and/or metal debris may accumulate on the speed sensor magnet. Too much accumulation may
result in interruptions in motor support and/or inaccurate speed readings. Regularly check your speed sensor
magnet for an accumulation of dirt and/or metal debris, and clean accordingly. The frequency of the cleaning
depends on your riding conditions, ride frequency and/or brake pad material. Removing metal debris may
require the use of a magnet stronger than the speed sensor magnet.
The speed sensor must be installed before assembling the horst pivot flip chip.
1: Open the grommet and place it over the speed sensor cable.
2: Slide the speed sensor into the chainstay at the dropout.
3: Using a 3 mm hex key, tighten the screw, then torque to specification.
When assembling the rear brake disc, the speed sensor magnet must be installed on the rotor. Four of the six bolts are standard rotor bolts.
The remaining two bolts (M5 x 0.8 pitch x 15 mm length, with a countersunk flat head) attach the speed sensor magnet to the rotor.
PAGE
16
2022
TECHNICAL GUIDE
Содержание LEVO 2022
Страница 1: ...SCHEMATIC SMALL PARTS 2022 TECHNICAL GUIDE...