Spearhead
Multi-Cut
420
8
Before fitting the PTO, first clean and grease. Remove the clamp bolts on the yoke
and slide onto the machine gearbox, refit the bolts into the grove tighten 150Nm. Pull
back the PTO release ring and slide onto tractor stub shaft until it engages.
The PTO shaft is fitted with a non-rotating safety guard. It should be secured to the
machine and tractor with the two retaining chains provided.
Connect the hydraulic hose, to a single acting service, with a dump facility. This is
important so the wings can follow the ground contours in work.
Connect the top link and adjust to ensure there is some slack in the wire ropes,
before raising the machine.
Raise the parking stands and secure locking pin.
Parking
stands
Fig 2
