Spearhead AGRICUT
240 Offset
28
'Running Up' the Machine
Before Use
Ensure that all operators have read and thoroughly understood all
the safety procedures. For further information refer to the relevant
sections of this manual.
Running the Machine for the First Time
Ensure that the machine and the PTO shaft have been correctly
connected to t
he tractor as stated in the ‘machine attachment
sections’ of the manual.
Select a safe open area in which to ‘run-up’ and check the
machine. Ensure there are no children, bystanders or animals in
the immediate area when the machine is run for the first time.
After the machine has been attached to the tractor for the first time, it should be tested
to ensure it operates correctly before putting it to work. Use the following procedure
when running the machine for the first time.
1. Lower the machine so the skids are resting on the ground and the machine is
level.
2. With the tractor at low revs, gently engage the PTO until the machine is running.
3. Carefully increase the PTO speed to 540 rpm.
4. Check that the machine runs smoothly and without vibration.
5. Raise the machine to the transport position.
6. Check again that the machine runs smoothly and without vibration.
7. Lower the machine to ground level again.
8. Gently reduce the tractor revs to idle, and disengage the PTO.
9. Apply the parking brake and stop the tractor.
If
any faults are identified, refer to the ‘Troubleshooting Guide’. If a solution is still not
found consult your local Spearhead Dealer or assistance.
