22
Start-Up Guide
GENERAL MAINTENANCE
Rod Guide
The rod guide is an integral part of the coiler which will increase the longevity of the push rod if maintained correctly . By allowing the
guide material to wear out first, it significantly decreases wear to the push rod jacket . Please clean all parts thoroughly with clean water
if dirt builds up .
Connector and Cable Care
Connectors and cables are an integral part of any system . Taking good care of these will allow the electrical signals to reliably transmit . It
is therefore essential to check the cable, connectors and interfaces after each inspection .
• Ensure the system is disconnected from the power supply .
• Check connector pins are all intact, clean, and no visible damage is present on the cable .
• Check O-rings for damage and replace if necessary (grease regularly) .
• If damage is located, contact Spartan Tool, LLC or its authorized agents .
NOTE:
Depending on the camera system and year of manufacture, a variety of different cables and connectors will
have been used, but the principle of care remains the same .
CLEANING AND MAINTENANCE
To increase the service life of your TrapJumper equipment, we recommend the devices and components are kept clean and serviced . To
achieve the greatest improvement in longevity, pay close attention to moving parts like rollers . Spartan Tool, LLC also notes a significant
reduction in the danger of catching infections from the equipment if cleaned thoroughly after each use .
The following list provides a guide on some care and maintenance measures that should be applied when operating TrapJumper
equipment . This will not replace repairs and maintenance entirely but should prolong the life of the equipment and reduce time spent
with Spartan Tool, LLC Service Department or its authorized agents .
• Always be vigilant and clean/replace parts after every inspection according to their condition .
• Check for loose parts after every inspection .
• Clean camera heads with water after use and remove all debris (a soft brush may be required) .
• Ensure the connector contacts are clean, use an electrical contact cleaner, if cleaning is required .
• Use clean water only . Don't add any cleaning products .
• If the Explorer control keypad/screen has been used in the rain, dry with a clean cloth and leave open until all water has
evaporated .
• Keep all power leads, chargers and accessories clean and dry .
• Clean all parts that have had contact with the inspection area thoroughly and wipe them over with a cloth if necessary after
every use .
• Roll cables up neatly after use and store in a dry area .
WARNING:
Never use a high pressure cleaner or any cleaning agents on any of the Explorer equipment . It may result
in damaging components, O-ring and increase the need for repair .
NOTE:
It is the sole responsibility of the user to keep the equipment to a good standard, any repairs required due to
negligence will invalidate the warranty and will be chargeable .
