15
Start-Up Guide
The following guide offers instructions on how to set up your TrapJumper system correctly and safely . Please read these instructions in
full before the system is set up . Your TrapJumper system has been built to your specification, the camera and overall setup remains the
same . Please pay close attention to any
Notes
and
Warnings
.
CAMERA CONNECTION AND REMOVAL
1 . Compress the spring together to reveal
the connector .
2 . Using a 12mm wrench (as below), screw
the male connector into the rod .
Spring end
12mm Wrench
Tighten
Loosen
3 . Finally, screw the spring over the rod
connector hand tight .
Repeat this process in reverse to remove the camera head .
NOTE:
If the spring is difficult to unscrew when removing the camera, use the camera removal tool provided in the
accessory kit . Align the inner tool with the end of the spring (see above) and apply the required force .
WARNING:
Wear gloves! The spring thread contains sharp edges and should not be touched without hand
protection . Take care with the connector thread and avoid extreme force .
Do not over tighten!
NOTE:
Always ensure the connector is clean and the electrical contacts remain grease free at all times .
