Spark SS-36-N, Руководство владельца по эксплуатации и инструкции

Страница: 26 / 36

POSSIBLE CAUSE REMEDY OBSERVED PROBLEM
TROUBLESHOOTING
Continued
or replace burner orifice
2.
Damaged burner
2.
Replace damaged burner
3. Gas regulator
defective 3. Replace gas regulator
Slight smoke or odor during
1.
Residues from manufactur-
1.
Problem will stop after a
initial operation
ing processes few hours of operation
3.
Gas regulator defective
3. Replace gas control
ments (page 4)
gas line checked by local
natural or propane/LP
gas
company
or replace burner orifice
white powder residue
2.
Battery is not installed.
2. Replace
batteries in receiver
Battery power is low. and remote control
Heater produces a whistling
noise when burner is lit
Moisture/condensation
1.
Not enough combustion/
1
. Refer to Airfor Combustion
no
ticed on windows
ventilation air and Vcntilation require-
1.
Air in gas line
1.
Operate burners until air is
removed from line. Have
White powder residue form- 1. When heated, vapors from
1
. Turn heater off when using
ing within burner box or on furniture polish, wax, car-
furniture polish, wax, clean-
adjacent walls or furniture pet cleaners, etc. turn into ers, or similar products
Remote does not function
1. Remote receiver "locked".
1.
See instructions supplied with
e Remote Control
2. Air passageways on heater 2. Observe minimum installa-
blocked lion clearances (see page 10)
Burner backfiring during 1. Burner orifice is clogged or
I.
Clean burner (see Cleaning
combustion damaged a nd Maintenance, page 23)
2.
Not enough air
2.
Check burner for dirt and
debris. If f ound, clean
burner (see Cleaning and
Maintenance,
page 23)
3. Dirty or partially clogged 3. Clean burner (see Cleaning
burner orifice
and Maintenance,
page 23 )
26