Spark SS-36-N, Руководство владельца по эксплуатации и инструкции

Страница: 20 / 36

Continued
APPROVED LEAK TESTING METHOD
You may check for gas leaks with the following methods only:
• Soap and water solution
• An approved leak testing spray
• Electronic sniffer
NOTE: Remove any excessive pipe compound from
the connections. Excessive pipe compound can set
off electronic sniffers.
"INSTALLATION AND OPERATING INSTRUCTIONS FOR SKYTECH MODEL: 1001 T/LCD-A" .
OPERATING INSTRUCTIONS
Check for gas leaks in each of the following locations:
• Pipe from the gas supply line connection to the gas valve
•
Burner connections, pilot
•
Field made joints / gas shutoff valve
•
All joints on valve and control body
•
Factory made joints, each joint and connection
WA
If using a soap and water solution to test
for leaks, DO NOT spray solution onto
electronic parts
.
WARNING
Never use an open flame to check for gas leak.
DANGER
1.
STOP! Read the safety information on previous page.
2. Turn off all electric power to the appliance.
3. Do not attempt to light the pilot by hand.
If you don't smell gas, go to the next step.
WARNING
7. Turn the gas control manual valve to the ON position.
8. Plug supplied 7V DC adapter into 110V power outlet.
LIGHTING FOR THE FIRST TIME
5. Turn the gas control manual valve to the full OFF position.
6. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.
If you smell gas, STOP! Follow "B" in the safety information (see page 7).
9. Connect the wire to the DC input plug at the unit.
11. Locate Remote Receiver inside of the unit
(see Illustrated Parts List, page 13).
Make sure that the slider switch
13. Read and follow instructions in how to set up and to use remote control described in supplied
14. If the appliance will not operate, follow the instructions "To Turn Off Gas To Appliance" and call
your service technician or gas supplier.
of the Receiver is in "REMOTE" (middle) position.
10. Lift and remove Heat Shield covering electronic components inside of the unit
(see Illustrated Parts List, page 13).
12. Replace Heat Shield and then replace Front Tray.
4. Remove Optional Media Tray (or Floor Panel) from the appliance
(see Illustrated Parts List, page 14).
2 0