www.spacemanusa.com
Phone: (720) 328-1020
Email: [email protected]
CAUTION: Never force the installation of any parts. All parts fit correctly
without force. If parts don’t seem to fit, remove all parts and repeat assembly.
2. Install drive shaft
a. Place drive shaft gasket on drive shaft
b. Seal gasket open space with Spaceman lubricant, extending onto drive shaft
and avoiding the top square part
c. Insert drive shaft into rear shell bearing at the back of the cylinder, and turn it
until the key engages firmly into the socket (when inserted correctly, the drive
shaft will no longer turn 360°)
1
3b
2c
3a
4a
3c
4c
4d
11
2a
2b
4b
Cleaning: 4. Assemble
1. Verify machine
power switch is in
the OFF position
3. Install beater assembly
a. Install scraper blade clips (2) onto scraper
blades (2)
b. Fit scraper blades onto beater
c. Insert assembly into cylinder; turn assembly
until it engages the drive shaft key and no
longer turns 360°
4. Install torque assembly
a. Place O-ring on torque assembly, coating with
Spaceman lubricant
b. Place torque guide onto the short end of the torque
assembly; DO NOT lubricate this component
c. Insert torque assembly into pilot hole in the center
of the drive shaft (torque guide first), ensuring that
torque guide DOES NOT fall off
d. Rotate torque assembly so the hole for the torque
arm is vertical, facing up and down
2b