Soyer BMS-10P, Руководство по эксплуатации

Страница: 38 / 54

38
6.5 Quality control
The quality control serves to monitor the reproducibility of the welding process and to report
inadmissible deviations. Thus changes can be detected which impair the quality of the welding results.
All welds are monitored when the quality control is switched on. The current weld in real-time is always
compared with the stored reference values. If these values are outside the specified tolerance, the
stud welder will be locked for welding operation. It can be reset by pressing the LIFT key or ENTER
key.
Pristine condition and regular maintenance of the entire welding equipment (welding gun/head, CNC
table, robot, earth connections etc.) are prerequisites for the successful application of the quality
control.
The SK-5AP welding head or PS-3A / PS-3P welding guns are suitable for the quality control when
equipped with a measuring lead (special design).
6.5.1 Setting up the quality control
Before using the quality control system, it is necessary to determine desired values for the welding
program to be used. Please proceed as follows:

Set operation mode "OP".

Set parameters required for the welding task. Carry out test welds. If need be, readjust
parameters.

Set operating mode "MEAS“ when the welds correspond to the quality desired.
NOTE
Parameters cannot be altered in operating mode "MEAS".
The following message appears on the display:
Call the option "Record new measured values" by pressing the "Arrow right" key.