Soyer BMS-10P, Руководство по эксплуатации

Страница: 11 / 54

11
1.2 Staff qualification and training
The staff responsible for operation, maintenance, inspection and assembly must have the respective
qualification for carrying out these works. Field of responsibility, competence and the supervision of
staff must be carefully regulated by the user. If your personnel do not have the necessary knowledge,
they must be trained and instructed. If necessary, this can be done by the manufacturer/supplier on
behalf of the user. Furthermore, the user must ensure that the contents of the operating instructions
have been fully understood by the staff.
The society of welding institutes (GSI: Gesellschaft der Schweißtechnischen Institute mbH) offers the
appropriate training courses for your personnel.
For information on branches, please refer to website
http://www.dvs-ev.de .
1.3 Dangers in the case of non-compliance with safety instructions
The non-compliance with safety instructions may not only endanger persons, but also the equipment
and its environment. Any non-compliance with safety instructions may result in a complete loss of
damage claims.
The following dangers may result if the safety instructions are not complied with:

Failure of important system functions

Failure of prescribed methods for maintenance

Danger to persons through electrical, mechanical, thermal and/or acoustic influences.
1.4 Before starting to weld...

Check the state of all cables and cable connections before starting to weld

Immediately replace defective cables and cable connections.
1.5 Working with the stud welding equipment
Comply with all accident prevention regulations applicable to the operation of your welding device.
If an accident happens,

switch off the welding device and disconnect it from the mains supply and

call a doctor
1.6 Inadmissible operating methods
Limit values
The working safety of the stud welding equipment is only guaranteed when the system is used in
accordance with its purpose. The limit values indicated in the chapter “Technical data” must never be
exceeded.
1.7 Stopping the stud welding equipment

Turn off the mains switch of the stud welding equipment.

Disconnect the mains plug from the mains socket.

In case of automatic operation, disconnect the compressed-air supply.

Disconnect the earth cable from the stud welder.

Disconnect welding gun or head from the stud welder.

Roll up the cables without buckling them.

Prevent the stud welder being operated by unauthorized personnel.

Check welding cables and connections of the stud welder for damage such as burn-off,
mechanical wear etc. and have damaged parts replaced by the SOYER customer service.