Manual P/N 211.410K
Updated 11292018
12
Flame Pack Series 400 Operation and Service Manual
7.0: Changing Batteries
1.
MAKE SURE RANGE SWITCH IS OFF.
2.
Loosen ¼ turn screw. Pull black handle
to remove.
3.
Remove spacer. Remove old batteries
from battery bracket/handle assembly
by pulling each one straight away from
contacts.
4.
Install fresh batteries.
5.
Reinstall spacer.
6.
Slide spacer down in between batteries
so that the “ears” are resting on the
batteries. When replacing the black
handle, make sure the spacer
attachment string is inside.
NOTE:
Although the batteries cannot be
installed backwards, a momentary
contact in this position with the power
on can damage the circuit board.
7.
We recommend using 9-volt alkaline
batteries because they will provide
longer service.
CAUTION: NEVER STORE FLAME PACK WITH BATTERIES INSTALLED.
NOTE: REMOVE BATTERIES WHEN STORING OR SHIPPING THE FLAME PACK.
Figure 5: Changing Batteries
