DIRECTIONAL ARROW SWITCH
PAGE 3
INSTRUCTIONS FOR LED TRAFFIC MASTER:
ETTMLEDW3 and ETTMLEDDRA
(
STANDARD WIRING SETUP: LOOKING AT BAR, CABLE EXITS ON THE LEFT REAR
)
Pink Wire (Warning Two)
Connect to Pink Wire of the Traffic Master
Yellow Wire (Warning One)
Connect to either the Green or Purple wire of the traffic master (depending on the desired
flash pattern)
Blue Wire (Left Arrow Direction)
Connect to Dark Green wire of the Traffic Master.
Brown Wire (Center Arrow Direction)
Connect to Yellow wire of the Traffic Master.
Green Wire (Right Arrow Direction)
Connect to Blue wire of the Traffic Master.
Please see page 10 for instructions on how to change between center output options.
Configure to apply power to the brown wire (Center Option 1)
Note: If you are using optional wiring, then the Dark Green and Blue wires must swap.
Blue Wire (Left Arrow Direction)
Connect to the Blue wire of the Traffic Master
Green Wire (Right Arrow Direction)
Connect to the Dark Green wire of the Traffic Master.
To turn off the end warning, press the warning button. To turn off the arrow functions press the
arrow button.
BLACK
GROUND
+10-30Vdc
RED
YELLOW
PINK
GREEN
BLUE
YELLOW
PINK
GREEN
PURPLE
BLUE
Either-or
NOT BOTH
+10-30Vdc
+10-30Vdc
RED
WHITE/RED
BLACK
PURPLE
