1.800.338.7337 / www.soundoffsignal.com
2
7X3 POLYCARB_WARNING 1121
7X3 SCREW MOUNT PART NUMBERS
EPSSC0JX(x)-(x) - SCREW MOUNT
SCREW MOUNT INSTALLATION
1. Drill (4) 5/16 holes to mount light. Drill 3/4" wire hole. See
Fig. 2
2. Insert well nuts into the 4 drilled holes. Fully seat to
mounting surface.
3. Align the gasket to the mounting surface.
4. Pull the wire harness through the opening and plug into
the back of the light.
5. Place light into gasket, pressing light and gasket against
mount surface.
6. Place bezel over the light.
7. Secure the bezel/light to mount surface using (4) supplied
screws.
DO NOT USE POWER
TOOLS TO TIGHTEN
NOTE: Horizontal and vertical orientations indicated
on gasket for proper seal.
NOTE: Tighten until gasket is compressed. DO NOT
overtighten and strip well nuts. DO NOT use power
driver.
WIRE HOLE
BEZEL
WIRE HARNESS
GASKET
SCREWS
WELL NUTS
SCREW MOUNT LIGHT SHOWN
FIG. 1
