Sorvall TC6, Руководство по обслуживанию

Страница: 16 / 109

TC6 ® Installation and Operation
2-1
Section 2: INSTALLATION and OPERATION
This section contains information to install and operate your SORVALL

TC6
®
Tabletop Centrifuge.
C A U T I O N
The centrifuge can be dam-
aged if connected to the wrong volt-
age. Check the voltage before plug-
ging the centrifuge into any power
source. Sorvall is not responsible for
incorrect installation.
!
W A R N I N G
The TC6 ® weighs 70 lbs.
Refer to the unpacking instructions
for proper care when lifting and in-
stalling the centrifuge. Failure to use
proper lifting techniques can result in
personal injury and/or possible dam-
age to the centrifuge.
C A U T I O N
Do not lift the centrifuge by
the front panel or the door. To do so
can result in damage to these parts.
!
2-1. Inspection
When you receive your centrifuge, carefully inspect it for any signs
of shipping damage. If you find damage, report it immediately to
the transportation company and file a damage claim, then notify
Sorvall.
Check the parts received with the centrifuge against the shipping
list; if any parts are missing, contact Sorvall (see office list in back of
manual).
2-2.␣ Preinstallation Require-
ments
The TC6 ® centrifuge is ordered for a specific voltage. The nameplate
on the back of the centrifuge tells the voltage ordered. Before using
the TC6
® , be sure the proper operating voltage and corresponding
fuse is selected. If required (for instruments serial number 9501733
and below), the voltage setting and fuses can be changed (refer to
page 2-2, paragraph 2-4, Voltage Selection for procedure to change
the voltage).
Other preinstallation requirements include:
• providing a flat, level surface to support the weight of the
centrifuge (31 kg; 70 lbs),
• allowing adequate space for proper air circulation (5 cm;
2␣inches),
• allowing for the proper height clearance to open the chamber
door (78.7 cm; 31.0 inches); and
• providing the proper electrical requirements.
!