13
Operation
E.2 Commissioning
help
E.3 Free
commissioning
If you decide not to use the commissioning help, you should make the necessary settings in
the following sequence:
- Menu 10.
Language (see 15.)
- Menu 3.
Time, date and operating times (see 8.)
- Menu 5
Settings for heat circuit, all settings (see 10.)
- Menu 6.
Protective functions if necessary (see 11.)
- Menu 7.
Special functions if necessary (see 13.)
Finally, menu 4.2 under operating mode „Manual“ should be used to test the switch outputs
with the consumers connected, and to check the sensor values for plausibility. Then switch on
automatic mode.
brief descriptions of each parameter in the display. Pressing the „esc“ key takes you
back to the previous value so you can look at the selected setting again or adjust it if
desired. Pressing the „esc“ more than once takes you back step by step to the selec-
tion mode, thus cancelling the commissioning help. Finally, menu 4.3 under operating
mode „Manual“ should be used to test the switch outputs with the consumers connec-
ted, and to check the sensor values for plausibility. Then switch on automatic mode.
The
fi
rst time the controller is turned on
and after the language and time are set,
a query appears as to whether you want
to parametrise the controller using the
commissioning help or not. The commis-
sioning help can also be terminated or
called up again at any time in the special
functions menu. The commissioning help
guides you through the necessary basic
settings in the correct order, and provides
Caution
Observe the explanations for the the individual parameters on the follo-
wing pages, and check whether further settings are necessary for your
application.
Caution
Observe the explanations for the the individual parameters on the follo-
wing pages, and check whether further settings are necessary for your
application.