XAV-AX200/AX200C2
5
DESTINATION SETTING METHOD
When the MAIN board or U310 on the MAIN board is replaced,
the destination setting is necessary.
Note 1:
Remote commander is necessary.
It is necessary to operate by the remote commander, even in case of
models that have not been supplied the remote commander.
(Refer
to
“ACCESSORIES” on page 61 about the remote com-
mander)
Note 2:
When discriminating the destination, refer to “MODEL IDENTI-
FICATION” on page 4.
1. Destination Setting
Set destination according to the procedure below.
1-1. Setting the Destination Code
Procedure:
1. Refer to
“3. DISASSEMBLY” on page 19, disassemble until to the
state that side A of MAIN board can be seen
.
Note 1:
The following is an image view. Be sure to refer to “3. DISAS-
SEMBLY” on page 19 for detail.
top cover
mechanism deck
2. Short-circuit the shortland (SL001) on the MAIN board by sol-
dering.
rear
side
front
side
– Top view –
3. Connect the power cord to the regulated DC power supply, and
turn the power on this unit.
Note 2:
It is not necessary to install the top cover and mechanism deck
that were removed in step 1.
+
–
Regulated DC
power supply
top cover
mechanism deck
4. Press the [HOME] button on the main unit.
[HOME] button
(Displayed screen in the above
fi
gure are example)
5. In the state of source off (Home screen is displayed), enter the
destination setting mode by pressing the buttons on the remote
commander in order of the [4]
t
[5]
t
[6] (press only the [6]
button for two seconds).
(Displayed screen in the above
fi
gure are example)
6. The following screen is displayed and the destination setting
mode becomes effective.
Note 3:
Refer to “1-2. Entering the Destination Code” on page 6 for op-
eration method.
<DESTINATION SETTING MODE>
0
0 0 0 0 1
EUR:*00000
LA(LA/ET4):*00003
FT(JPN):*00007
UC:*00001
E17:*00012
(Displayed characters/values in the above
fi
gure are example)
7. Refer to
“2. Con
fi
rmation After Destination Setting” on page 7, and
con
fi
rm a correct destination was set.
8. Disconnect the power cord from the regulated DC power sup-
ply, and turn the power off this unit.
+
–
Regulated DC
power supply
– Continued on next page –
SYS SET
2018/04/20 05:09:38 (GMT+09:00)
