XAV-AX200/AX200C2
XAV-AX200/AX200C2
30
30
For Schematic Diagrams.
Note:
• All capacitors are in
μ
F unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in
Ω
and 1/4 W or less unless otherwise
speci
fi
ed.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
•
: Pattern from the side which enables seeing.
(The other layers’ patterns are not indicated.)
Note 1:
When the complete MAIN board is replaced, be sure
to refer the following, and perform them.
• DESTINATION SETTING METHOD (page 5)
• COMMUNICATION CHECK OF Apple CarPlay
AND Android Auto (page 7)
• FLICKER ADJUSTMENT (page 25)
Note 3:
Replaced old complete TFT board is destroyed with
the hammer, and throw out it.
Note 2:
When the complete TFT board is replaced, be sure to
refer the following, and perform them.
• COMMUNICATION CHECK OF Apple CarPlay
OR Android Auto (page 7)
• FLICKER ADJUSTMENT (page 25)
Note 4:
Among mounted electrical parts on each board, only
parts that are described in the electrical parts list can
be replaced for repairing.
The parts that are not described in the electrical parts
list cannot be replaced with single for repairing.
MAIN board
SXM board
TUNER board
TFT board
SERVO board
(US, CND)
• Circuit Boards Location
Note 1:
When the complete MAIN board is replaced, be sure
to refer the following, and perform them.
• DESTINATION SETTING METHOD (page 5)
• COMMUNICATION CHECK OF Apple CarPlay
AND Android Auto (page 7)
• FLICKER ADJUSTMENT (page 25)
Note 3:
Replaced old complete TFT board is destroyed with
the hammer, and throw out it.
Note 2:
When the complete TFT board is replaced, be sure to
refer the following, and perform them.
• COMMUNICATION CHECK OF Apple CarPlay
OR Android Auto (page 7)
• FLICKER ADJUSTMENT (page 25)
Note 4:
Among mounted electrical parts on each board, only
parts that are described in the electrical parts list can
be replaced for repairing.
The parts that are not described in the electrical parts
list cannot be replaced with single for repairing.
Caution:
Pattern face side:
(SIDE B)
Parts face side:
(SIDE A)
Parts on the pattern face side seen
from the pattern face are indicated.
Parts on the parts face side seen from
the parts face are indicated.
SXM BOARD
(SIDE A)
SXM BOARD
(SIDE B)
A
B
1
2
3
4
A
D
B
C
1
2
3
SXM BOARD
5-5. PRINTED WIRING BOARD - SXM Board (US, CND) -
5-6. SCHEMATIC DIAGRAM - SXM Board (US, CND) -
•
: Uses unleaded solder.
• See the left for Circuit Boards Location.
SYS SET
2018/04/20 05:09:38 (GMT+09:00)
