62
Additional Information
KLV-HG26M1/KLV-SG21M1
2-179-781-
E1
(2)
Remote Control Configuration for VCR/DVD
This remote control is set by default to operate the basic functions of this Sony TV, most Sony
DVDs and Sony VCRs when batteries are initially installed. To control VCRs and DVDs of other
major brands, and certain Sony VCR models, please complete the following steps:
Before you start, look up the three digit code for your brand of DVD or VCR from the list
on page 63. For those brands that have more than one code, enter the first code number.
1
Press the Media Selector button on the remote control repeatedly
until the required VCR or DVD green light lights up.
If the Media Selector is in the TV position, code numbers
will not be stored.
2
Before the green light goes out, press and hold the yellow button
for approximately 6 seconds until the green light starts flashing.
3
Whilst the green light is flashing, enter all three digits of the code
for your brand (see page 63) using the number buttons on the
remote control.
If your selected code is entered correctly, all three green
lights will be lit momentarily.
4
Turn on your VCR or DVD and check that the main functions
work.
• If your equipment is not working or some of the functions
do not work, enter the code again.
If your equipment is still not working correctly, please
check you entered the correct code set or try the next code
listed.
• Your brand codes may be lost if weak batteries are not
replaced within a few minutes. To reset your DVD or
VCR code number, please repeat the above steps. A small
label is attached inside the battery cover to allow you to
record your brand codes.
• Not all brands are covered and not all models of every
brand are covered.
1
3
2
01gb01co.book Page 62 Thursday, July 29, 2004 4:45 PM
