Sony VPL-FE100E, Руководство по эксплуатации

Страница: 31 / 120

31
(GB)
Setting the Index Numbers
0
1
Ten’s digit Unit’s digit
When you connect multiple projectors in your system,
you have to set the group index and device index
numbers for each projector.
To set the group index number
If you set the same group index number for multiple
projectors, you can operate multiple projectors and
switchers simultaneously (such as input selection) by
designating the number.
The group index number can be set in the menu.
For group index number setting, see page 26 (GB).
To set the device index number
If you set the device index number, you can control
each projector individually with the supplied Remote
Commander.
The device index number can be set with the DEVICE
INDEX switches on the rear of the projector. It is set to
“01” at the factory.
If only one projector is connected, set it to “01.”
Notes
• Do not set the same device index number for the
projectors in the same system.
• Do not set the number to “00.” If you do, the
projector will be operated only with the keys on the
control panel. It cannot be controlled with the wired
or wireless Remote Commander, or with an external
equipment to which the PJ COM connectors are
connected.
Set the same group
index number.
Set the different
group index number
for two systems.
Set the same group
index number.
Set this switcher to 1.
PC-3000
PC-3000
Projector
PC-3000
Projector
Projector
Signal flow
Signal flow
Signal flow
PJ COM
Signal flow
PJ COM
PJ COM
PJ COM
PC-3000
PC-3000
Projector
Notes on setting of the index number
• Set the same group index number for all
equipment of the same system connection (those
on the signal route between the signal source and
the projector).
For setting the group index number, see “GROUP INDEX”
on page 26 (GB).
• Set the correct group and device index numbers
and the switcher number.
Do not set the same device index number or the same
switcher number in one group.
For example, if there are different pieces of
equipment with the switcher number 1, the error
message will appear when the SYS SET key is
pressed.
• Set the switcher that outputs the signal to the
projector to number 1.