Sony UWP-V1, Руководство по обслуживанию

Страница: 11 / 164

1-7
UWP Series
1-3. URX-M2
1-3-1. Removal/Installation
m
.
Before installing the URX-M2, make sure the MB-806A
into which the URX-M2 will be installed is turned off. Do
not install or uninstall the URX-M2 while the MB-806A is
turned on, as this may damage the connector or cause noise.
. The buttons and display on the front panel of the URX-
M2 may be damaged if they are gripped too strongly.
Always hold the URX-M2 by the side.
. Do not put your fingers on the connectors on the rear
panel of the URX-M2 or into the slot on the unit into
which the URX-M2 will be installed.
.
Keep the URX-M2 away from static electricity.
1. Tuner Base Unit MB-X6 / MB-806A
When using the MB-X6
Removal
1. Loosen the screws at both sides of the front cover, then
slide the front cover downward.
2. Hold the screws by the head and pull forward to
remove the front cover.
3. Remove the tuner unit URX-M2 from the slot in the
direction of the arrow.