Sony SRX-R320, Руководство по установке

Страница: 56 / 126

2-10
SRX-R320
X-axis direction
adjusting screw
Y-axis direction
adjusting screw
Fig. 2-2d
Status message
dispaly
START STOP
SAVE
_ +
[SAVE]
button
[+]
,
[_]
button
[START]
button
Fig. 2-2e
Fig. 2-2f
8. Click the
[START]
button in a “Lamp Adjust” menu
on the “LAMP INFORMATION” window.
The unit enters the lamp adjustment mode.
9. Wait for fi ve minutes.
10. When the unit enters the lamp adjustment mode, the
value of the internal luminance sensor is displayed on
the status message display.
Adjust “Z Axis Adjust” using the
[+]
/
[_]
button so
that the luminance value becomes maximum.
n
A lamp bulb is not installed when this unit is shipped
from the factory. Therefore, an “F34/F35 ADJUST-
MENT ERROR” message may be displayed on the
status message display and SRX Controller at the rear
of this unit before this adjustment is performed. This
message disappears when you press the
[Save]
button
after Z axis adjustment.
11. In the same way, adjust the X-axis and Y-axis direction
adjusting screws so that the value of the internal lumi-
nance sensor becomes maximum.
12. Adjust “Z Axis Adjust” again using the
[+]
/
[_]
button
so that the value of the internal luminance sensor
becomes maximum.
13. Click the
[Save]
button.
14. Age this unit for fi ve minutes.
15. Click the
[CALIBRATE]
button.
n
Click the
[CALIBRATE]
button after at least 10
minutes turning on the lamp.