Sony RM-PJM600, Руководство по обслуживанию

Страница: 22 / 106

1-18
34
(GB)
Unsuitable Installation
Poorly ventilated
• Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes. When the internal heat
builds up due to the block-up, the temperature sensor will
function with the message “High Temperature! Power off
in 1 min.” The power will be turned off automatically
after one minute.
• Leave space of more than 30 cm (11 7 /
8
inches) around
the unit.
• Be careful that the ventilation holes may inhale tininess
such as a piece of paper.
Highly heated and humid
• Avoid installing the unit in a location where the
temperature or humidity is very high, or temperature is
very low.
• To avoid moisture condensation, do not install the unit in
a location where the temperature may rise rapidly.
Very dusty
Avoid installing the unit in a location where there is a lot of
dust; otherwise, the air filter will be obstructed. The dust
blocking the air through the filter may cause raising the
internal heat of the projector. Clean it up periodically.
Do not install the projector in the following situations. These installations
may cause malfunction or damage to the projector.
35
(GB)
Notes on Installation
No toppling of the unit
Avoid using as the unit topples over on its side. It may
cause malfunction.
Use to be level
Do not install the unit other than on the floor.
Avoid using as the unit tilts to one side or tilts upward or
downward more than 20 degrees. These installation may
cause malfunction.
No blocking the ventilation holes
Avoid using something to cover over the ventilation holes;
otherwise, the internal heat may build up.
Carry out the followings.
20° 20°