104
Recording does not stop after you press
x
STOP.
,
Open the remote’s cover and press
x
REC
STOP.
Timer recording is not complete or did not start
from the beginning.
,
There was a power failure during recording.
Should the power failure continue for more than
1 hour, reset the clock (page 89).
,
Disc space was not enough.
Contents previously recorded were erased.
,
Data that has been recorded on a DVD with a PC
will be erased from the disc when the disc is
inserted.
,
“Auto Title Erase” in the “Features” setup is set
to “On” (page 97).
Nothing was recorded even though you set the
Synchro-Recording setting correctly.
,
You forgot to turn off the connected equipment.
Turn off the connected equipment and set the
recorder to Synchro-Recording standby mode
(page 56).
,
The recorder was not set to the Synchro-
Recording standby mode. Press SYNCHRO
REC to have the recorder stand by for recording.
Make sure the SYNCHRO REC indicator lights
up on the front panel (page 56).
,
The recorder is connected to the TV output jack
of the connected equipment.
Synchro-Recording does not complete.
,
The timer setting for the connected equipment
overlapped the recorder’s timer setting
(page 57).
,
There was a power failure during the recording.
The recorder automatically starts recording
when the satellite receiver is turned on.
,
The Synchro Rec function was activated. Turn
off the satellite receiver and cancel the Synchro
Rec function (page 56).
The clock has stopped.
,
Set the clock again (page 89).
,
The clock stopped due to a power failure that
lasted for more than one hour. Reset the clock
(page 89).
The clock is wrong.
,
Set the clock again (page 89). If you cannot set
the clock, wait until the clock data is received
and the clock is automatically adjusted.
The TIMER REC indicator is flashing.
,
The disc does not have enough space.
,
Insert a recordable disc inside the recorder.
The recording mode indication is incorrect.
,
When the recording or dubbing is less than three
minutes, the recording mode indication may be
displayed incorrectly. The actual recording itself
is correctly made in the selected recording mode.
,
After playing titles recorded in SLP and SEP
mode, the recording mode indication may
change depending on the recorded program.
The clock does not appear in the front panel
display.
,
“Dimmer” in “Options” setup is set to “Power
Save” (page 98).
The remote does not function.
,
Batteries are weak.
,
The remote is too far from the recorder.
,
The remote’s manufacturer code returned to the
default setting when you replaced the batteries.
Reset the code (page 22).
,
Turn on the recorder.
,
The remote is not pointed at the remote sensor on
the recorder.
,
Different command modes are set for the
recorder and remote. Set the same command
mode (page 24). The default command mode
setting for this recorder and the supplied remote
is DVD3.
,
Set the TV/DVD switch to DVD (page 24).
Recording from the equipment
with a timer
Display
Remote control
