O
p
tiona
l Com
pone
nts
71
GB
Notes
• If you cannot select “SAT” by pressing TV/SAT
repeatedly, hold down TV/SAT and then press
?/1
while the power is on. The function will change from
“TV” to “SAT”, and “SAT” will appear in the
display. To change back to “TV”, repeat the same
procedure.
• If the sound is distorted or too loud when “TV” is
selected or you want to switch back to “SAT”, repeat
the operation described above to switch to “SAT”.
• You cannot switch the TV/SAT function in Power
Saving Mode (page 63).
1
Connect a digital optical cord.
See “Hooking up optional components” on
page 69.
2
Connect 6 speakers to an AV amplifier
equipped with a decoder.
For the speaker placement, refer to the
operating instructions supplied with the
connected amplifier.
3
Switch the output to 5.1 channel Dolby
Digital sound or 5.1 channel DTS
sound.
See “Changing the sound” on page 35.
Tip
You cannot use the surround effect of this system.
1
Connect audio cords.
See “Hooking up optional components” on
page 69.
2
Start recording manually.
See “Recording on a tape manually” on
page 54.
Making an analog recording
1
Connect audio cords.
See “Hooking up optional components” on
page 69.
2
Start recording.
Refer to the operating instructions provided
with the connected component.
Making an analog recording
from a VIDEO CD to a video
tape
1
Connect optional audio cords from the
TV/SAT OUT L/R (audio) jacks and the
supplied video cable from the VIDEO
OUT jack to your VCR.
2
Start recording.
Refer to the operating instructions provided
with the connected component.
Note
If the picture has disturbance or there is noise in the
audio when a TV, a video deck and this system are all
connected at the same time, disconnect one of them.
Enjoying the 5.1 channel
sound with the optional
amplifier
(MHC-GNZ7D/GNZ5D only)
Recording audio from a
connected component
(Except for MHC-GNZ5D)
Recording on a connected
component
(Except for MHC-GNZ5D)