Sony KV-32XBR400, Руководство по обслуживанию

Страница: 16 / 126

— 16 —
KV-32XBR400/36XBR400/36XBR400H/38DRC1/38DRC1C
3-2. V-PIN and V-CEN ADJUSTMENT
Before beginning adjustment procedure:
•
Input a cross hatch pattern signal.
•
Face the picture tube in North/South direction and correct
rotation.
•
Video Mode: Standard (Reset)
1. Adjust service mode CXA2150D-1 04 VCEN so that top
pin and bottom pin are symmetrical from top to bottom.
2. Adjust service mode CXA2150D-1 05 VPIN so top and
bottom pin are symmetrical from top to bottom.
3. Lines should be straight from left to right. Check landing for
side effect.
3-3. CONVERGENCE ADJUSTMENT
Before starting convergence adjustments:
•
Set CONTRAST AND BRIGHTNESS control to 50%.
•
Input dot pattern signal.
Vertical and Horizontal Static Convergence
1. Disconnect dynamic convergence before adjusting static
convergence (CN5510), except for minor touch-up.
2. Adjust H.STAT convergence, RV 9001, to converge red,
green and blue dots in the center of the screen.
3. Adjust V.STAT magnet to converge red, green and blue
dots in the center of the screen.
4. Tilt the V.STAT magnet and adjust static convergence to
open or close the V.STAT magnet.
B
G
R
B
G
R
Operation of BMC (Hexapole) Magnet
The respective dot positions resulting from moving each
magnet interact, so perform the following adjustment while
tracking.
Use the V.STAT tabs to adjust the red, green, and blue dots
so they line up at the center of the screen (move the dots in
a horizontal direction.)
HMC Correction HMC Correction
R G B
A=B
A B
R G B
A=B
A B
R
G B
A>B
A B
R
G B A<B
A B
VMC Correction
R
G
B
C<D
C
D
R
G
B
C=D
VMC Correction
R
G
B
C<D
C
D
R
G
B
C=D
TLH Plate Adjustment
•
Input crosshatch pattern.
•
Adjust unbalanced horizontal convergence of red and blue
dots by adjusting TLH plate on the deflection yoke.
TLH Plate
RV9002
RV9001
W Board
C Board
TLV
XCV
1. Adjust XCV core to balance X axis.
2. Adjust vertical red and blue convergence with V.TILT
(TLV VR).
Note: Perform adjustments while tracking item 1.