24
AUDIO (analog audio signal) input connector
(LINE) (stereo mini jack)
Inputs analog audio signals.
f
REMOTE contact switch connectors 1 to 4
(stereo mini jack)
Use these to control the unit via contact switches.
Contact switch connector 4 outputs input signals
from contact switch connector 3 via pass-through,
and returns the status of the pass-through destination.
For details on contact switches, see “[Contact
Switch] Tab” (page 75).
g
USB port 7 (Type B / USB 2.0)
Use this to perform system controls from an external
device.
For details, see “[Control] Tab” (page 74).
h
Network connector (RJ-45)
Connect a 1000 Base-T or 100 Base-TX network
cable here.
Caution
For safety, do not connect the connector to peripheral
device wiring that might have excessive voltage.
Follow the instructions for use for this port.
i
USB ports 3 to 6 (Type A / USB 2.0)
Connect USB devices here.
Supported USB devices
• Use Sony USB media.
• The connectors do not support all USB devices.
• USB hubs and devices with built-in hubs are not
supported.
Warning
Using this unit for medical purposes
The connectors on this unit are not isolated.
Always use USB-compatible external hard drives and
USB memory devices that operate solely on the
power supplied by the unit.
Connecting a device that operates on an AC power
supply may result in an influx of leakage currents
from the connected device, which may in turn result
in electric shocks to the patient and operator.
If use of such devices cannot be avoided, be sure to
connect an isolation transformer to the power supply
of the connected device or connect an isolator
between the connection cables to isolate the power
supply, and verify that the risk of electric shock from
the system has been sufficiently reduced to levels that
conform to IEC 60601-1 standards.
j
MENU MONITOR connector (15-pin mini
D-sub)
Connect a touch panel monitor or similar device here.
k
RS-232C connector (9-pin D-sub)
Use this to perform system controls from an external
device.
For details on system controls, see “[Control] Tab”
(page 74).
1
Video I/O block
a
DVI-D input connectors 1 and 2 (single link)
Input DVI signals.
The signal from DVI-D input connector 1 is input to
Ch1, and the signal from DVI-D input connector 2 is
input to Ch2.
b
DVI-D output connector (single link)
Outputs DVI signals.
c
SDI input connectors 1 and 2 (BNC type)
Input SD-SDI, HD-SDI, or 3G-SDI signals.
The signal from SDI input connector 1 is input to
Ch1, and the signal from SDI input connector 2 is
input to Ch2.
• If SDI input images are not displayed, turn on the
unit first and make sure that startup is complete
before turning on the video input device.
• Embedded audio is not supported.
d
SDI output connector (BNC type)
Outputs SD-SDI, HD-SDI, or 3G-SDI signals.
e
VIDEO output connector (BNC type)
Outputs analog composite video signals.
f
VIDEO input connector (BNC type)
Inputs analog composite video signals.
Tip
Tip
Tips
Содержание HVO-3300MT
Страница 99: ......