1-15 (E)
HDVF-C950W
1-8. Extending the Circuit Board
Fixture required: PR/RE extension assembly
n
Life of flexible card wire will be significantly shortened if
it is folded. Be very careful not to fold the flexible card
wire.
1-8-1. Service Position
1.
Remove the rear cover assembly.
(Refer to Section 1-7-1 step 1.)
2.
Disconnect the two harnesses from the connectors
(CN11, CN12) of the PR-292 board. (Refer to Section
1-7-1 step 2.)
3.
Remove the bezel assembly.
(Refer to Section 1-7-1 steps 3 to 5.)
4.
Insert the claws of the CN box bracket (L)/(R) into the
grooves (L)/(R) of the LCD bracket as shown in the
figure.
1-8-2. RE-237 Board
1.
Set the unit to the service position.
(Refer to Section 1-8-1.)
2.
Remove the RE-237 board.
(Refer to Section 1-7-4 step 3.)
3.
Connect the PR/RE extension assembly (EX-1017
board side) to the connector (CN4) of the PR-292
board.
4.
Install the PR/RE extension assembly (EX-1018 board
side) with the screw to the CN box bracket.
n
Fix the EX-1018 board to the position shown in the
figure with the screw (B3
x
8) removed from the rear
cover.
5.
Connect the RE-237 board to the connector of the PR/
RE extension assembly (EX-1018 board side).
Groove of the LCD
bracket (R)
Claws of the CN box
bracket (L)/(R)
Groove of the LCD
bracket (L)/(R)
Groove of the LCD bracket (L)
B3
x
8
PR-292
board
PR/RE extension
assembly
RE-237 board
EX-1018 board
EX-1017 board
CN1
CN4
