1-14 (E)
HDVF-C950W
1-7-9. Removing the Harness (VF)
1.
Remove the rear cover assembly.
(Refer to Section 1-7-1 step 1.)
2.
Remove the bezel assembly.
(Refer to Section 1-7-1 steps 2 to 5.)
3.
Remove the screw and remove the GND terminal.
(Refer to Section 1-7-3 step 4.)
4.
Disconnect the harness from the connector (CN1) of
the PR-292 board. (Refer to Section 1-7-3 step 5.)
5.
Disconnect the harness from the connector (CN2) of
the PR-292 board and remove it toward the front of the
machine through the CN box bracket
A
hole.
(Refer to Section 1-7-3 step 6.)
6.
Remove the two screws and remove the arm cover (L).
7.
Disconnect the harness through the tilt shaft (L) hole
in the direction of arrow.
n
Be careful not damage the harness (VF).
8.
Disconnect the VF connection cable from the harness.
9.
Remove the four screws (P2.6
x
5), and remove the
GND terminal, the bottom plate and harness from the
pan arm.
10. Remove the harness from the arm lift shaft in the
direction of arrow.
n
Be careful not damage the harness (VF).
11. Remove the two screws (M2
x
5) and remove the
harness (VF) from the bottom plate.
12. Reinstall it by reversing the steps 1 to 11 of disassem-
bling.
BTTP2.6
x
8
Tilt shaft (L) hole
Arm cover (L)
Harness (VF)
Bottom plate,
harness (VF)
VF connection cable
Harness (VF)
P2.6
x
5
Bottom plate
GND terminal
Arm lift shaft
Pan arm
Harness (VF)
Harness (VF)
M2
x
5
