11
Troubleshooting
Troubleshooting
If you encounter a problem using this adapter, use the following checklist to find a solution.
For any problems with the transmitter or receiver, refer to the operating instructions of the
respective device. If the problem persists, consult your Sony dealer.
Symptom
Meanings
Remedy
The DWR-S01D or
the WRR-855S does
not turn on.
The DWR-S01D or the
WRR-855S is not correctly
inserted into the slot of the
camcorder or this adapter.
Insert the DWR-S01D or the
WRR-855S until it is firmly and
completely in, and then secure it
with the mounting screws.
No signal is output
from the OUTPUT 2
connector when the
adapter is connected
to the device that
accepts the analog
signal only.
The tuner 2 of the
DWR-S01D is not turned
on.
Turn on the tuner 2 of the
DWR-S01D.
The WRR-855S is
attached to the adapter.
The WRR-855S is a single-channel
receiver. Thus, there is no signal
output from the OUTPUT 2
connector.
There is noise in the
audio output from
the digital device that
is connected to the
adapter.
The DWR-S01D inserted
in the adapter and the
digital device that is
connected to the adapter
are not in synchronization.
If the connected device is not
compatible with the asynchronous
input (i.e., the sampling rate
converter is not equipped), use the
word clock signal to synchronize
the device.
The WORD SYNC IN
connector is not 75-ohm
terminated.
When the DWR-S01D that is
inserted in the adapter is the end
device or when the master word
clock signal is input to this adapter
only, add the 75-ohm termination to
the WORD SYNC IN connector by
using the UTILITY menu of the
DWR-S01D.
Mixed audio from
tuner 1 and 2 is
heard from the left
channel of the
monitor output.
The ANALOG OUTPUT 1
function of the DWR-S01D
is set to RX1+2.
Set the function to RX1.
If it is set to RX1+2, mixed audio
from tuner 1 and 2 will be output for
the monitor output.
