Adam Hall GmbH · Adam-Hall-Str. 1 · 61267 Neu-Anspach · Germany
Tel.: (+49) 60 81 / 94 19 0 · Fax: (+49) 60 81 / 94 19 1000 · eMail: [email protected]
1
2
2
12
SAFETY INFORMATION
1. Please read these instructions carefully.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Observe all safety warnings. Never remove safety warnings or other information from the equipment.
5. Use the equipment only in the intended manner and for the intended purpose.
6. During installation, observe the applicable safety regulations for your country.
7. Never place sources of ignition, e.g., burning candles, on the equipment.
8. Do not use this equipment in the immediate vicinity of water (does not apply to special outdoor
equipment - in this case, observe the special instructions noted below. Do not expose this equipment to
flammable materials, fluids or gases.
9. Make certain that dripping or splashed water cannot enter the equipment. Do not place containers filled
with liquids, such as vases or drinking vessels, on the equipment.
10. Make certain that objects cannot fall into the device.
11. Use this equipment only with the accessories recommended and intended by the manufacturer.
12. Do not open or modify this equipment.
13. After connecting the equipment, check all cables in order to prevent damage or accidents, e.g., due to
tripping hazards.
14. During transport, make certain that the equipment cannot fall down and possibly cause property
damage and personal injuries.
15. If your equipment is no longer functioning properly, if fluids or objects have gotten inside the equipment
or if it has been damaged in another way, switch it off immediately and unplug it from the mains outlet
(if it is a powered device). This equipment may only be repaired by authorized, qualified personnel.
16. Clean the equipment using a dry cloth.
17. Comply with all applicable disposal laws in your country. During disposal of packaging, please separate
plastic and paper/cardboard.
18. Plastic bags must be kept out of reach of children.
CAUTION – HIGH VOLUME LEVELS WITH AUDIO PRODUCTS!
This equipment is intended for professional use. Therefore, commercial use of this equipment is subject to
the respectively applicable national accident prevention rules and regulations. As a manufacturer, Adam Hall
is obligated to notify you formally about the existence of potential health risks. Hearing damage due to high
volume and prolonged exposure: When in use, this product is capable of producing high sound-pressure
levels (SPL) that can lead to irreversible hearing damage in performers, employees, and audience members.
For this reason, avoid prolonged exposure to volumes in excess of 90 dB.
To prevent possible hearing damage, avoid listening at high volume levels over long periods
of time. Even exposure to short bursts of loud noise can result in hearing loss. Please keep
the volume constantly at a comfortable level.
MANUFACTURER’S WARRANTY & LIMITATION OF LIABILITY
You can find our current warranty conditions and limitation of liability at:
https://cdn-shop.adamhall.com/media/pdf/MANUFACTURERS-DECLARATIONS_LD_SYSTEMS.pdf
To request warranty service for a product, please contact Adam Hall GmbH, Adam-Hall-Str. 1,
61267 Neu Anspach / Email [email protected] / 49 (0) 6081 / 9419-0
PROPER DISPOSAL OF THIS PRODUCT
(WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT)
(Valid in the European Union and other European countries with waste separation)
This symbol on the product, or the documents accompanying the product, indicates that this appliance
may not be treated as household waste. This is to avoid environmental damage or personal injury due to
uncontrolled waste disposal. Please dispose of this product separately from other waste and have it recycled
to promote sustainable economic activity.
Household users should contact either the retailer where they purchased this product, or their local government
office, for details on where and how they can recycle this item in an environmentally friendly manner.
Business users should contact their supplier and check the terms and conditions of the purchase contract. This
product should not be mixed with other commercial wastes for disposal
CE CONFORMITY
Adam Hall GmbH hereby confirm that this product meets the following guidelines (where applicable):
R&TTE (1999/5/EC) or RED (2014/53/EU) from June 2017 / Low-voltage directive (2014/35/EU)
EMC Directive (2014/30/EU) / RoHS (2011/65/EU) / The full declaration of conformity can be found at
www.adamhall.com. You can also request it via [email protected]
EN
USER´S MANUAL
CURV 500
®
SLA (W) / CURV 500
®
S2 (W)
SMARTLINK ADAPTER FOR UP TO FOUR LD CURV 500® SATELLITES /
TWO ARRAY SATELLITES FOR THE CURV 500® PORTABLE ARRAY SYSTEM
CONNECTIONS, CONTROLS, MECHANICS
1
Release button LD CURV 500® satellite
2
Guide rail LD CURV 500® satellite
3
Grooves SmartLink® Adapter or LD CURV 500® satellite
4
Locking system
5
Contacts
6
Satellites 1 / 2: 16 mm flange for 1 to 2 satellites (upright position).
7
Satellites 3 / 4: 16 mm flange for 3 to 4 satellites (forward tilt position).
8
Input Signal: Speakon-compatible speaker input. The speaker input is parallel wired with the terminal
block connection
9
.
9
Terminal Block Connection: Terminal block connection for permanent installation and desktop application
(terminal block included). The terminal block connection is parallel wired with the Speakon-compatible
speaker input
8
.
10
M6 thread: Two M6 threads for attaching the wall mounting bracket LDCURV500WMB. One of the threads
in the truss mounting is used for mounting an M6 safety eyelet (not included).
11
M6 thread: Two M6 threads for attaching the wall mounting bracket LDCURV500WMB, or the truss mount-
ing adapter LDCURV500TMB.
12
M3 thread: M3 thread to secure the LD CURV 500 satellites in permanent installations.
13
Rubber feet: 4 rubber feet provide stability for desktop applications. For the installation of the ceiling
mount bracket LDCURV500CMB, unscrew the rubber feet (M3 thread).
SETUP
Slide a CURV 500® satellite from the rear onto the SmartLink® adapter until it stops, while pressing the
spring-loaded release button
1
on the side of the satellite. Ensure that the two guide rails
2
of the satellite
slide properly into the grooves
3
on the top of the SmartLink adapter (or CURV 500® satellite) in order to ensure
a tight fit and establish a contact for both components. Now release the button to lock the connection and to bring
the button back to its original position. Proceed in the same manner as described above to add other satellites.
When disassembling, please proceed in reverse order. For fixed installations and desktop applications, a terminal
block connection (terminal block included) is located on the back of the SmartLink® adapter. The Speakon-com-
patible speaker input INPUT SIGNAL
8
is parallel wired with the terminal block connection
9
.
For more information about setting up and wiring, please refer to the user’s manual of the LD CURV 500®
portable array system on WWW.LD-SYSTEMS.COM.
SPECIFICATIONS
Product number
LDCURV500S2(W)
Product type
PA Complete Systems Accessories
Type
Array Satellites
Midrange size
1 x 4 "
Tweeter dimensions
3 x 1 "
Load rating (RMS)
40 W
Peak power
80 W
Dispersion
110° horizontal, vertical (each satellite) 10 °
Impedance
16 Ohm(s)
Material
die-cast aluminium
Surface
Powder coated
Colour
Black (LDCURV500S2), white (LDCURV500S2W)
Width
122 mm
Height
122 mm
Depth
122 mm
Weight
3.44 kg
Features
SmartLink® System, internal crossover, M3 thread for safety rope
for installations, metal grille, WaveAhead® Technology
Product number
LDCURV500SLA(W)
Product type
PA Complete Systems Accessories
Type
Smartlink® Adapter
Material
die-cast aluminium
Surface
Powder coated
Connectors
1x Phoenix, 1x Speakon compatible
Colour
Black (LDCURV500SLA), white (LDCURV500SLAW)
Width
122 mm
Height
122 mm
Depth
57 mm
Weight
0,35 kg
Features
2 x 16 mm flanges, 2x M6 thread for optional wall mount
3
3
4
5
LDCURV500SLA - CURV 500
®
SmartLink
®
Adapter
SmartLink® adapter with connections and stand flange as the base for up to 4 CURV 500® array satellites.
3
3
4
5
9
11
11
6
7
8
9
11
11
10
10
13
LDCURV500SL2 - CURV 500® Satellite Speaker
Two CURV 500® array satellites with the patented click mechanism and WaveAhead® technology.
