Sony DSR-2000A, Руководство по обслуживанию

Страница: 34 / 234

3-10
DSR-2000A/2000AP
Removal/Reattachment of the control panel
(1) Remove the nine knobs.
(2) Hold the handles of the control panel and open the
control panel. Lift up the control panel with the
handles until it comes horizontally.
(3) Remove the three screws.
(4) While pressing the release lever, bring back the control
panel to the original position until the angle between
the control panel and the unit comes to about 45
degrees.
(5) Move the control panel in the arrow direction, and
release the three claws to remove the control panel.
[Reference] [Reference] [Reference] [Reference] [Reference]
Applying the pulling downward force will make it
easy to remove the control panel.
(6) Fit the three claws of the control panel into the three
square holes of the control frame assembly.
(7) Bring the control panel to the position of Step (2), and
while pressing it from the top, reattach it with the three
screws.
(8) Turn the nine volume shafts fully counterclockwise.
(9) Align the nine knobs with the position holes of the
control panel and thrust into as far as they will go.
[Reference] [Reference] [Reference] [Reference] [Reference]
If the knob easily comes off, widen the slot on the
volume shaft using a flat tip screwdriver.
(10)Check that the knob’s turning range is within the
double-headed arrow shown in the figure by turning
the nine knobs clockwise and counterclockwise.
Knobs
PWH3 x 6
PWH3
x
6
PWH3 x 6
Handle
Handle
Control panel
Lift up in the
horizontal
position
Knob‘s turning range
Square
holes
Claws
Control panel
Control frame assembly
At angle up to 45 d
Square hole