Sony DSR-2000A, Руководство по обслуживанию

Страница: 182 / 234

7-52
DSR-2000A/2000AP
Replacement
1. Removing the pinch limiter assembly
Remove the pinch limiter assembly.
(Refer to Section 7-5.)
2. Removing the pinch solenoid
assembly
Remove the pinch solenoid assembly.
(Refer to Section 7-7.)
3. Replacing the reel shift motor
assembly
(1) Disconnect the harness of the reel shift motor
assembly from the connector (CN5) on the
MS-64 board with tweezers.
(2) Remove the screw to remove the reel shift
motor assembly.
(3) Fit two holes in a new reel shift motor
assembly shown in the figure on the two pins
on the MD chassis and engage it with the
gear A.
(4) Reattach the reel shift motor assembly with
the screw.
Tightening Torque : 0.1 N
. m {1 kgf . cm}
(5) Reconnect the harness of the reel shift motor
to the connector (CN5) on the MS-64 board.
4. Reattaching the pinch solenoid
assembly
Reattach the pinch solenoid assembly.
(Refer to Section 7-7.)
5. Reattaching the pinch limiter
assembly
Reattach the pinch limiter assembly.
(Refer to Section 7-5.)
CN5
P1.4 x 3.5
MS-64 board
Gear
Pin
Positioning hole
Reel shift mortor assembly