Sony DNW-30P, Руководство по обслуживанию

Страница: 39 / 116

2-3
DNW-A30/A30P
DNW-30/30P
5. Unhook the claws at the upper control panel from the
chassis, and remove it in the direction of the arrow.
For installation, perform in the reverse procedures of removal.
n
Insert the hooks at the back of the panel into the convex
portions of the chassis, then install the panel in the chassis.
(Refer to the figure below.)
2-3. Removal/Installation of Cabinet
Upper Lid
1. Loosen three fixing screws.
2. Remove the upper lid by moving in the direction
indicated by the arrow.
For installation, perform in the reverse procedures of removal.
Side Panels
(The right and left side panels are the same in procedure.)
1. Remove four screws (B3
x
6), and remove the handle.
2. Remove four screws (B4 x 6), and remove the side
panel.
For installation, perform in the reverse procedures of removal.
Bottom Plate
n
.
With the handle attached, place the unit on its right side
panel down for removal and installation. Lend your hand
so that the lower handle does not hang down.
1. Remove six screws (B4 x 6), and remove the bottom
plate.
For installation, perform in the reverse procedures of removal.
2-3-2. Control Panels Removal/Installation
n
Turn off the power and unplug the power cord before
starting the removal/installation.
Upper Control Panel
1. Remove the upper lid.
(Refer to “2-3-1. Upper Lid, Side Panels, and Bottom
Plate Removal/Installation”.)
2. Remove the each one screw on the left and right sides.
3. Take both side handles on a lower control panel and pull
them slightly forward, then pull them more strongly.
Then the lower control panel tilts upward (to 90 degrees
position).
4. Unhook two hooks at lower portion on the upper
control panel.
Hooks
Lower control panel
BVTT3 x 6
BVTT3 x 6
Upper control panel
Claws
Upper control panel
Hook
Hook
BVTT3
x
6
BVTT3 x 6