Sony DMX-R100, Руководство по эксплуатации

Страница: 119 / 134

119
Chaper 4 Operation Tips
Chapter 4 Operation Tips
Cases Dialogues and remedies
The tape recorder does not start operation
even though 2 seconds have elapsed
when MIDI controlling the tape recorder.
When you copy data between the buffers A and B:
When you execute MAKE STATIC function:
When you try to change the initial cue
while automation is being run:
There are cues to be deleted
if you change the timecode of the initial cue.
You try to create the cue with the timecode
that is a lower value than the Cue 1 value.
When you touch the FADER CAL. button in
the MISC SETUP window.
When the calibration is completed, the following dialog
appears to confirm whether you want to save the results
on the unit or not.
When you touch the 1-24 CH button in the FADER COPY
section in the COPY/LINK window.
When an error occurs in a diagnosis while running DSP.
“Switching MIDI Machine Control to OPEN LOOP.”
[OK] (Switched in open loop control
mode.)
“Are you sure you want to copy automation data?
Destination buffer will be overwritten”
[YES] (Execute copying.)
[CANCEL] (No action)
“Are you sure you want to erase automation data?”
[YES] (Execute erasing automation data.)
[CANCEL] (No action)
“Initial cue timecode value can not be changed, while
automation is in ‘RUN’”
[OK] (No action)
“You are changing initial cue timecode value. Cue(s)
proceeding the initial cue timecode value will be deleted.”
[YES] (The timecode is changed)
[CANCEL] (No action)
“The cue has not been stored as the timecode value is
before the initial cue.”
[OK] (No action)
“Touch YES for automatic fader calibration. Please keep
faders area clear and don’t touch any faders during
calibration. This will take around 60 seconds.”
[YES] (Execute the calibration.)
[CANCEL] (No action)
“Touch YES to save the new fader calibration data”
[YES] (Save the new fader calibration data)
[CANCEL] (Revert to the original calibration
data.)
“Touch YES to copy the settings for 24 faders
simultaneously”
[YES] (Execute the fader copying.)
[CANCEL] (No action)
“We have a DSP error! Please reboot.
Error Code: 0x########” (######## indicating 8-digit
error code)
[OK] (Close the message.)
When the above message appears, the output will be
muted. Perform SAVE or KEEP as required, turn the
power of the unit OFF once. Then, reboot again.
Possible causes:
• When this error occurs frequently, the reference
sync signal may change suddenly, or is unstable.
• The inside of the unit increases in temperature,
when the ventilation holes of the unit are blocked.
• There is the static electricity discharge or there is
a heavy noise source near the unit.
Check the above cases, then remove a cause.