109
Chaper 4 Operation Tips
Chapter 4 Operation Tips
8
Drop out the automation data using one of the
following methods.
• Touch the MASTER DROP IN button on the
window to turn its color to dark red.
• Touch the numerical value of the items subject to
automation.
• Release the fader.
• Stop the tape recorder.
Automation data for the items set in WRITE mode
in step 6 is written.
Notes
• If a lot of items are dropped in (go into “write
mode”)/out ( cancel “write”) at the same time using
the MASTER DROP IN button, data near the drop in/
drop out point may not be stored and recalled
instantaneously.
• Automation items in WRITE mode are removed from
snapshot recall and control using MIDI.
Updating automation data
The data for the automated items is recalled according
to timecode. To update automation data, set the
desired automation items to READY, then drop them
into WRITE.
You can select either ABS mode or TRIM mode to
update data, using the ABS button or the TRIM button
within the TC AUTOMATION buttons on the
Automation panel.
In ABS mode or TRIM mode, you can set the return
mode and the speed to return to the previous data from
the new data in the AUTO RETURN TIME section in
the AUTOMATION window.
For details on the return mode (ABS and TRIM), see figures
on the next page.
To update automation in ABS mode
Set the tape recorder to play and drop in the desired
automation items (go into WRITE). The method used
to “drop-in” depends on faders, controls and buttons as
explained below.
•
To drop in faders,
touch the fader knob its
numerical value displayed on the window.
When you drop in by touching the fader knob, you
can drop out (cancel WRITE) by releasing the fader,
if the WRITE HOLD or TOUCH HOLD mode is not
specified.
When you drop in by touching the numerical value
displayed on the window, you can drop out using one
of the following methods:
— Touch the numerical value again.
— Press the WRITE button for that channel.
— Touch the MASTER DROP IN button.
— Stop the tape recorder.
•
To drop in buttons,
push them.
The button automatically drops in.
You can drop out using one of the following
methods:
In ABS mode
—Press the WRITE button for that channel.
—Touch the MASTER DROP IN button.
—Stop the tape recorder.
In Trim mode, release a button to drop out
automatically.
For items dropped in, replay of previously recorded
automation is replaced by new automation data.
When dropping out, faders and other controls return to
the previous automation data and replay of the
previous data continues according to the method
specified in the AUTO RETURN TIME section in the
AUTOMATION window.
Note
• When HOLD TO END is specified, the status of
faders, controls and switches at the drop out point are
held and stored as automation data to the end of the
title.
• When TOP TO END is specified, the status at the
drop out point is held and stored as automation data
from the beginning to the end of the title.
Содержание DMX-R100
