DSC-HX20/HX20V/HX30/HX30V_L2
1-18
Feed-Through
Cam Tube
Focus Lens
Sliding Groove
Feed-Through Cam Tube
qj
qk
ql
Align the Step with the Focus Lens Sliding Groove and install the Lens Block to the Feed-Through Cam Tube.
Engage the Projections of the Cam Tube (B) Assy and the Straight Tube (B) with the eleven Grooves of the Feed-Through Cam Tube.
Turn the Naruto Gear jig clockwise to set the Main body at TELE end.
Note:
Turn the Naruto Gear jig to the maximum.
wa
Install the Naruto Gear.
Note:
Set the Naruto Gear with its deeper hole facing down.
Naruto Gear jig
Naruto Gear
Lens Block
Cam Tube (B) Assy,
Straight Tube (B)
Up side
Down side
w;
Pass the Flexible Boards through the holes and engage the four Convexes on the Flexible Boards with the four Claws.
Flexible Boards
Holes
Claw
Claw
Claws
Outside
Step
ws
Install the Rear Mirror Plate Assy and the Zoom Motor Gear Block and secure them with six screws.
Note:
Tighten the screws in the order of numbers in the figure below.
wd
Install the Ornamental Ring (A) and the Barrier Assy.
Note:
For how to install the Ornamental Ring (A) and the Barrier Assy, refer to "1-8. Ornamental Ring A or Barrier Assy
Replacing Method."
3
5
2
4
6
1
Screws
Screws
Rear Mirror Plate Assy
Zoom Motor
Gear Block
Barrier Assy
Ornamental Ring (A)
DC2.5V
wf
wg
wh
wj
Connect one Flexible Board to the Connector.
Fix the three Bosses and a Convex on the Flexible Board, and then solder the Flexible Board at four locations.
Stick Adhesive Tape.
Apply a voltage of 2.5 V to the DC Motor and retract the Lens.
Adhesive Tape
Solders
Boss
Boss
Flexible Board
Boss
Convex