DSC-HX20/HX20V/HX30/HX30V_L2
1-12
1-
9
. ORNAMENTAL RING A OR BARRIER ASSY REPLACING METHOD
Barrier Assy
Claws
Claws
Barrier Assy
Barrier Assy
Claws
Claws
Installation
Removal
Ornamental Ring A
Disengage the four claws and remove the Barrier Assy.
Fit the four claws while inserting the Barrier Lever into the hole and attach the Barrier Assy.
Note:
The Barrier Tapes must not be wrinkled.
Peel off the release papers of the Barrier Tapes.
Install the Ornamental Ring A and press it lightly.
Turn on the power switch and extend the lens (TELE end).
Detach the battery.
Apply alcohol to four gaps
A
of the Ornamental Ring A with tweezers or a fine-tipped stick as shown below.
Turn the Ornamental Ring A clockwise and counterclockwise to detach it.
Barrier Tapes
Barrier Tapes
Ornamental Ring A
Solvent
A
A
Tweezers
Barrier Assy
Barrier
Levers
holes
Mark
Mark
1-
10
. ZOOM MOTOR GEAR BLOCK REPLACING METHOD
Removal
Installation
2
1
Remove the screw and remove the Zoom Motor Gear Block from the Main body.
Remove the FG Plate Spring while disengaging the two Claws.
3
4
Pull the two Sensors out of the Zoom Motor Gear Block.
Remove solder at two locations to detach the Zoom Motor Gear Block from the Main Flexible Board.
Zoom Motor
Gear Block
Zoom Motor
Gear Block
Zoom Motor
Gear Block
Solders
Sensors
Main Flexible Board
3
1
2
Solder the Main Flexible Board at two locations and insert the two Sensors into the Zoom Motor Gear Block.
Install the FG Plate Spring while engaging the two Claws.
Install the Zoom Motor Gear Block to the Main body and tighten the screw.
Screw
Zoom Motor
Gear Block
Zoom Motor
Gear Block
Screw
Zoom Motor
Gear Block
Claws
FG Plate
Spring
FG Plate
Spring
Zoom Motor
Gear Block
Claws
Solders
Sensors
Main Flexible Board
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.1 2012.05