![background image](http://html.mh-extra.com/html/sony/cmt-vp100/cmt-vp100_operating-instructions-manual_420471026.webp)
26
VIDEO CD/CD Player
There is no picture.
• Check that the system is connected securely.
• Make sure that you have operated the TV
correctly.
• Make sure that you have set the
SYSTEM SELECT to proper setting for the
color system of your TV.
• Turn FUNCTION to switch to the VIDEO CD/
CD function.
The VIDEO CD/CD will not play.
• The disc is dirty.
• The surface of the disc is scratched. Replace the
disc.
• The disc is not loaded properly.
• The disc is loaded with the label side down.
• Condensation has built up in the system.
Remove the disc and leave the system turned on
for about an hour until the moisture evaporates.
Play does not start from the first track.
• The player is in Program or Shuffle Play. Press
PLAY MODE repeatedly until “PGM” and
“SHUFFLE” disappear.
Tape Deck
Recording cannot be done.
• There is no tape in the cassette holder.
• The record protect tab has been removed from
the cassette (see page 24).
• The tape has come to the end.
The tape does not record or play, or there is a
decrease in sound level.
• The heads are dirty. Clean them (see page 25).
• The record/playback heads are magnetized.
Demagnetize them (see page 25).
The tape does not erase completely.
• The record/playback heads are magnetized.
Demagnetize them (see page 25).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty. Clean
them (see page 25).
Noise increases or the high frequencies are
missing.
• The record/playback heads are magnetized.
Demagnetize them (see page 25).
Tuner
There is a severe hum or noise (“TUNED” or
“STEREO” flashes).
• Adjust the antenna.
• The signal strength is too weak. Connect an
external antenna.
• Make sure that the antenna is connected
properly.
• Do not bend or roll up the antenna.
• The two wires comprising the FM antenna have
been pulled further apart since the system was
first purchased. Repair or replace with a new
one.
• The AM antenna wire is detached from the stand.
• Keep the antennas as far away from the speaker
cords as possible.
A stereo FM program cannot be received in
stereo.
• Press STEREO/MONO on the remote until
“STEREO” appears in the display.
Resetting the system
With the system turned on, press TAPE
x
,
CD
x
and TUNER BAND at the same time.
The system is reset to the factory settings. All
previous settings are cleared and must be set
again.
Messages
One of the following messages may appear or
flash in the display during operations.
NO DISC
• There is no disc on the disc tray.
PGM FULL
• You try to program 21 tracks or more.
Troubleshooting (continued)