Sony BVP-9500WS, Руководство по обслуживанию

Страница: 56 / 390

1-46 (E)
BVP-9500WS/9500WSP MM
1-10-5. Boards Inside CCD Unit
Prior to the performance of the following activities, remove the CCD unit and filter disk unit from the
camera. (Refer to Section 1-9-3.)
1. Removing the case
Remove the nine screws (a).
2. Removing the SH-69 board
Remove the three screws (b).
3. Removing the TG-194 board
(1) Remove the two screws (c).
(2) Desolder the Sub harness (EMI-A). (For BVP-9500WSP only.)
4. Removing the TG-203A board
(1) Remove the two supports and two screws (d).
(2) Disconnect the connector (CN4).
(3) Desolder the Sub harnesses (EMI-A), (EMI-B), and (EMI-C). (For BVP-9500WSP only.)
5. Removing the VA-189 board
Remove the screw (e).
6. Removing the NR-65 board
Disconnect the three connectors (CN2, CN3 and CN4).
7. Removing the DR-377A board
(1) Remove the two screws (f) securing the connector plate.
(2) Disconnect the flexible card wires (CN2, CN3 and CN4).
(3) Remove the support and screw (g).
n
Refer to Section 1-8 before disconnecting the flexible card wire.
8. Assembling
Assemble the unit in the reverse order of steps 1 to 7.
m
.
When attaching the SH-69 board, fit the protrusions on the NR-65 board to the notch and hole on
the SH-69 board.
. When replacing the TG-194 board, put off two shield sheets (TG) from the PR-249 board and then
put it on the new TG-194 board. (for BVP-9500WSP only.)
1-10. Replacing Boards